EMPI's HPMX carburettors are some of the best in the industry. In a head-to-head comparison, the HPMX was able to match and even surpass the performance of their Weber counterparts. Best of all, the HPMX is fully compatible with all IDF components, such as jets, emulsion tubes, etc. EMPI tests and adjusts each and every one of their carburettors at their Anaheim California facility prior to shipping.

HPMX dual 44mm ultra carburettor kit is there top of the line in the IDF style range and comes with the following:

• Mated version 2.0 carburettors set up in a left and right configuration

• Chrome velocity stacks

• Cast billet aluminium air cleaners with high flow gauze elements and built-in crossbar support

• Ball burnished extra thick offset aluminium intake manifolds, which positions the carburettors straight across the engine

• Aluminum alloy hex bar linkage

• Coil relocation bracket

• Fuel tee, fuel filter, and fuel line

• All the gaskets and hardware needed to bolt the kit to your engine

• Detailed instructions on how it all goes together

The carburettors are configured as follows:

• .55 idle jets

• .135 main jets

• .200 air jets

• 36mm venturi

• .550 exhaust pump jets

• .50 accelerator pump jets

• F-11 emulsion tubes

• Comes with 2 throttle return springs, but no means to install them. Fabricate a mount if you need to use the springs to make your throttle return to idle.

These specs are subject to change.

This kit would best suit engines 2000cc and over