Bent or broken fingers on throw out shafts are common when using high pressure clutches.

Shaft Arms Are Fully Welded For Optimum Strength, unlike the stock arm.

Comes complete with bushing, return spring, and heavy duty clips.

Suits all early clutch set ups with the "pad" in the clutch centre Beetle, Karmann Ghia, and Type 3 and Kombi 1961 up to 1970

Write a review

Your Name

Your Review

Note: HTML is not translated!

Rating Bad Good

Captcha

Please complete the captcha validation below

Heavy Duty VW Clutch Arm Repair Kit

Qty

Gearbox Gasket Set, All Swing And IRS GearboxesComes with input shaft seal Beetle up to '79&nb..

$41.58 Ex Tax:$36.16

Main Shaft Seal (Input Shaft Seal), 1961 to 1991 Manual gearbox. This seal is what keeps the ..

$19.15 Ex Tax:$16.65

This will do the clutch job properly, since a "cheap" one will just change the disc. ..

$271.57 Ex Tax:$236.15

Clutch Cable Conduit Beetle to 1974 Also called Clutch Cable Bowden Tube/Sleeve made in German..

$39.95 Ex Tax:$34.74

The stock VW clutch release bearing clip (The "U" shaped design) is a poor design, these heavy duty ..

$6.12 Ex Tax:$5.32

This is used on almost all air-cooled VW's that use a clutch cable. Includes Beetle, Type 3’s, Komb..

$10.98 Ex Tax:$9.55

All new racking throw out shafts are quanlity manufactured for direct replacement of worn, broken, o..

$75.41 Ex Tax:$65.57

Clutch Return Spring (On Gearbox), 1961 to 1971 Beetle , 1961 to 1971 Kombi, and 1961 to 1971 Type 3..

$10.34 Ex Tax:$8.99

Clutch Cable Clevis Pin. fits 1955 to 1972 Kombi’s This is what holds the front end of the ..

$10.19 Ex Tax:$8.86