VW Beetle 1961 to 1979,
VW Kombi 1960 to 1979 (with Type 1 based engine)
VW Type 3 1962 to 1972
VW Karmann Ghia 1961 to 1974
This is the bolt that holds the flywheel the crankshaft on VW Upright Engines, and also Type 3's.
This comes WITH the Needle Bearing (Pilot Shaft Bearing) inside the gland nut too.
Make sure to torque this to spec of 35 mkg (253 ft·lbf)
Note: Will not fit automatics also will not fit 36HP and some 1200cc 40HP engines as the threads are to long.
Flywheel Bolt (Gland Nut) VW 1300 to 1600 style engines
- Brands Original Supplier to Volkswagen
- Product Code:111 105 305E
- Availability:In Stock
-
$45.56
- Ex Tax:$39.62
Related Products
VW Engine Case Heavy Duty "Bubble Top" 90.5/92mm
Engine Case, with 10mm or 8mm head studs bosses, and spigots for 90.5/92mm cylinders..
$2,530.00 Ex Tax:$2,200.00
Clutch Pressure Plate for VW Beetle, Karmann Ghia, Type 3 and Kombi up to 1967 (180mm Dia.)
This will do the clutch job properly, since a "cheap" one will just change the disc. ..
$0.00 Ex Tax:$0.00
VW Chromoly Flywheel Bolt Heavy Duty made by CB Performance
CB Performance Gland Nut Don't take your chances on stock Flywheel Bolt (Gland Nut) performance app..
$78.56 Ex Tax:$68.31
8mm Competition Dowel Pin set
These Longer Length Dowel Pins Fit Deeper Into The Crankshaft To Protect Against Shearing Under..
$63.99 Ex Tax:$55.64
VW Clutch disc 200mm Sprung Centre
We have found these discs to be the best, even better than the German made disc's. For best operati..
$110.98 Ex Tax:$96.50
VW Beetle, Kombi Clutch Friction Disc 180mm Ridged Centre (Also Porsche 356 356A 356B)
For best operation and to complete warranty you must have your flywheel ground to a smooth finish an..
$207.66 Ex Tax:$180.57
KEP Performance Pressure Plate Stage 1 1700lb (200mm)
Pressure plate stage 1 Kennedy 1700lb 200mm, is a good plate to fit to any Mild, Offroad or Hig..
$0.00 Ex Tax:$0.00
Flywheel Shim, 1300-1600cc Engines, .24mm (.010')
Flywheel Shim, 1300 to 1600cc style engines, .24mm (.010") This is used to take up the excessive ga..
$4.51 Ex Tax:$3.92
Flywheel Shim, 1300-1600cc Engines, 0.32mm
Flywheel Shim, 1300 to 1600cc style engines, 0.32mm This is used to take up the excessi..
$4.51 Ex Tax:$3.92
Gland Nut Spigot Bearing
Transmission Input Shaft Pilot Bearing (In Gland Nut), This is inside the gland nut on 1200-1600cc..
$6.51 Ex Tax:$5.66
Quality Early Clutch kit 180mm with alignment tool for VW Beetle, Karmann Ghia, Type 3 and Kombi
This is the early 180mm style kit with the centre pad and is a quality kit. This clutch kit wa..
$458.46 Ex Tax:$398.66
VW Stock Flywheel 200mm 12 Volt 4 Dowel (Economy)
Stock Flywheel, 200mm, 12 Volt, 4 Dowel, Economy. This is a good quality flywheel for stock e..
$266.14 Ex Tax:$231.43
Starter Motor D-Bolt for VW Kombi 1950 and 1975 and All VW Beetles
Replacement starter motor D-bolt. Fits VW Beetles from 1946 to 2003, VW T2 Split Screens from 1950 t..
$6.01 Ex Tax:$5.23
EMPI Performance Pressure Plate Stage 1 1700lb (200mm)
Pressure plate stage 1 1700lb 200mm, is a good plate to fit to any Mild, Offroad or High ..
$367.75 Ex Tax:$319.78
VW Engine Case Heavy Duty "Bubble Top" 90.5/92mm With Sand Seal machined snout
Engine Case, with 10mm or 8mm head studs bosses, and spigots for 90.5/92mm cylinders..
$2,530.00 Ex Tax:$2,200.00
11/32" Competition Dowel Pin set
These Longer Length Dowel Pins Fit Deeper Into The Crankshaft To Protect Against Shearing Under High..
$55.94 Ex Tax:$48.64
Heavy Duty Gland Nut Washer
Heavy Duty Gland Nut Washer Only For VW Air-cooled Engines. Extra Strength Chromoly Steel Washe..
$16.93 Ex Tax:$14.72
VW Lower Engine Case Mounting Stud
The VW Lower Engine Case Mounting Studs are sold individually, 2 are needed per engine. The stu..
$10.34 Ex Tax:$8.99
Tags: flywheel, nut, gland, bolt, crankshaft,