Flywheel Shim, 1300 to 1600cc style engines, 0.36mm

This is used to take up the excessive gap between the main bearing and flywheel, oftern refered to as end float.

By using shims of different thicknesses, you can set the gap to spec 0.10mm (.005") to minimize bearing and case wear.

Will not fit 36hp and type 4 style engines

Write a review

Your Name

Your Review

Note: HTML is not translated!

Rating Bad Good

Captcha

Please complete the captcha validation below

Flywheel Shim, 1300-1600cc Engines, 0.36mm

Qty

Also called the Crankshaft Seal or as the Rear Main oil seal Quality Silicon Seal that we have..

$15.84 Ex Tax:$13.77

Sealing "O" ring for the flywheel fits manual and automatic flywheels. Fits 1965-1979 Volkswagens w..

$2.50 Ex Tax:$2.17

Flywheel Shim, 1300 to 1600cc style engines, .24mm (.010") This is used to take up the excessive ga..

$4.51 Ex Tax:$3.92

Flywheel Shim, 1300 to 1600cc style engines, 0.32mm This is used to take up the excessi..

$4.51 Ex Tax:$3.92

Transmission Input Shaft Pilot Bearing (In Gland Nut), This is inside the gland nut on 1200-1600cc..

$6.51 Ex Tax:$5.66

Stock Flywheel, 200mm, 12 Volt, 4 Dowel, Economy. This is a good quality flywheel for stock e..

$266.14 Ex Tax:$231.43